475HFA
BAXTER SAW™ – MODEL 475HFA
FULLY AUTOMATIC HORIZONTAL BANDSAW
The model 475HFA is a fully automatic bandsaw. This machine can cut solids and grating. It has an extra large capacity of 18” (460mm) x 36” (915mm). Machine can cut solids using a large 1½” (41mm) blade driven by a 7½ hp (5 kW) motor.
| CUTTING CAPACITY | |
| Round | 18″ (460 mm) |
| Rectangular | 18″ x 36″ (460 x 915 mm) |
| SPECIFICATIONS | |
| Blade Size | 1 1/2″ x 18′ 8″ (38 x 5690 mm) |
| Blade Speeds (ft/min) | 60, to 400 (18 to 122 m/min) |
| Blade Tension (spring compensated) | 30,000 psi (207 MPa) |
| Blade Guides | Carbide with rollers |
| Table Height | 26 1/4″ (660 mm) |
| Maximum Work Load | 7,000 lb. (3180 kg) |
| Machine Weight | 5,200 lb. (1900 kg) |
| Overall Dimensions | 119”x88”x80” (3020x2235x2030 mm) |
| DRIVE | |
| Blade Drive | 10 Hp (7.5 kW) |
| Hydraulic Dive | 3 Hp (2.25 kW) |
| Voltages available (three phase) | 575, and 460 |
MATERIAL FEED
- Material is feed via a shuttle vise
- Stroke of vise is 24″ (610 mm) with a length limit of 96″ (2440 mm)
- Length of cut accuracy to +/-.015″ (.4 mm), repeatability +/-.005″ (.1 mm)
FEATURES INCLUDED AS STANDARD EQUIPMENT
- Double column machine provides maximum capacity and rigidity
- Design utilizes linear bearings for high stiffness and smooth motion
- Hydraulic lift of the saw head
- Saw up travel can be set to minimize distance between the blade and the top of the material
- Saw down travel can be set to allow notching of blocks
- Electronic variable speed drive, panel adjustable
- Parts counter up to 9999
- Fully-automatic cut cycle, consists of material advance, saw cut at end of cut the saw head will raise to top, repeat until parts counter decrements to 0
- Manual saw control, saw up, rapid saw down, saw cut, vises open/close, shuttle advance/retract
- Cutting feed rate hydraulically adjusted
- Load sensing valve which stops the feed if the blade starts to overload, typical when cutting the web of structural shapes.
- Full stroke hydraulic vises, with stationary vise retract of 1/2” to avoid interference with material.
- Top vises with replaceable heavy flexible strip to clamp uneven material
- Variable vise pressure.
- Discharge table 37” wide by 24” long
- Steel wheel with ductile iron hubs
- Blade guides are carbide faced with rollers to remove blade twist and dampen vibration
- Flood coolant system to both saw guides and separate nozzle to allow coolant to center of cut with adjustable flow rates
- High efficiency direct drive planetary gear drive system
- Electric system uses only C.S.A./UL approved components and is electrically approved
- Premium quality bimetal bandsaw
blade, Instruction and parts manual
| OPTIONS |
| Conveyor |
| Crating Charges |
