The model 360SA is a rigid double column bandsaw machine with a large 14” (360mm) x 19” (480mm) capacity. Machine has hydraulic head lift and a semi-automatic cut cycle. Machine uses economical 1” blade and has a 2 hp (1.5 kW) drive. Blade speed is set using a five-step pulley.

Round 14″ (360mm)
Round at 45 degrees 10 3/4″ (273 mm)
Rectangular 14″ x 19″ (360 x 480 mm)
Blade Size 1″ x 13′ 6″ (27 x 4115 mm)
Blade Speeds 80, 125, 180, 265, 400 ft/min (25, 38, 55, 81, 122 m/min)
Blade Tension (spring compensated) 30,000 psi (207 MPa)
Blade Guides Carbide with rollers
Table Height 26 1/4″ (660 mm)
Maximum Work Load 3,000 lb. (1350 kg)
Machine Weight 1,400 lb. (636 kg)
Overall Dimensions 7’ x 4′ x 6′ (2130x1220x1830 mm)
Blade Drive 2 Hp (1.5 kW)
Hydraulic Drive 1 Hp (.75 kW)
Voltages available (three phase) 575, 460, 230 and 208


  • Double column machine provides maximum capacity and rigidity
  • Design utilizes linear bearings for high stiffness and smooth motion
  • Hydraulic lift of the saw head
  • Saw up travel can be set to minimize distance between the blade and the top of the material
  • Saw down travel can be set to allow notching of blocks
  • Semi-automatic cut cycle and manual saw control, saw up, rapid saw down, saw cut
  • Cutting feed rate hydraulically adjusted
  • Load sensing valve stops the feed if the blade starts to overload, typical cutting structural shapes
  • Magnetic motor starter with automatic shut off at the end of cut, motors thermal overload protection
  • Power disconnect on machine
  • Blade guards and fully enclosed drive belt guard
  • Powered blade brush to remove cutting chips
  • Quick acting material clamping
  • Miter cuts up to 45 degrees by swiveling vise
  • Adjustable material length stop for repetitive cutting
  • Cast ductile iron wheel
  • Blade guides are carbide faced with rollers to remove blade twist and dampen vibration
  • Flood coolant system to both saw guides with adjustable flow rates
  • Gear box designed for heavy duty bandsaw machines, precision worm shaft on taper roller bearings and phosphorous bronze worm gear set supported on sealed ball bearings, oil bath lubrication
  • All bearings are totally enclosed and lubricated for life
  • Electric system uses only C.S.A./UL approved components and is electrically approved
  • Premium quality bimetal bandsaw blade
  • Instruction and parts manual
Variable Speed Drive
Single Phase 220/1/60
Hydraulic Vise
Crating Charges

 Download Brochure